Love em.  Use very carefully. But a 3 pack to start off with. The largest go arround cock and scrotum at the same time. Dont be afraid to use 2 or 3 at once. Secnod largest arround base of cock and smallest just behind the tip under condon so it wont fall off. It's great to have your partner help with putting them on.    PS: Put them on before you add lube. Lube on the fingers can cause them to slip while they are streched and that can HURT!!.   my favorite is a cyber skin with 2 rings built in and a place on top to hold a small WIRELESS vibrating bullet. Turns a cock into a living squirting dildo.Great for the mileage!!

-- Modified on 5/12/2004 8:32:39 AM

Don't know much about cock rings, so sorry, can't be helpful there, but I do have some condom info. I really like beyond 7. Really great condoms, they stay on and have good sensitivity...if you are using Magnum, you may want to get the large size! Good luck! Octavia.

... much more BB experience.  Also safer.

-- Modified on 5/12/2004 9:53:52 AM

At least 3 clients of mine have used them, and I think they are very, very sexy on a man.  These gentlemen too had complained of poor staying power and believe the rings have helped immensely.  As far as the Magnums, besides the Magnum gold there are Magnum XL.  I also hear Beyond 7 are a good bet.  A condom large enough for the job, with a little bit of GOOD lube inside before putting it on, works just fine.

I find Cock Rings Difficult to get off and if you are clostraphobic could cause a revearse reaction.  I find it easier to take that little blue pill.  Works like a charm.

BM

Re:Would like feedback regarding cock rings

I make my own.

Very simple. All you need is some...
1) Rubber surgical tubing (available at any medical supply store.
2) Wooden craft beads (available at any craft store).

For the tubing you don't want it too small, because it can dig in to the skin too much. 3/8" to 1/2" diameter works best for me. 1/4" dia. can be OK but I think it is a little small.

Thinner wall tubing is more elastic and therefore preferred but it won't last as long.

You must match the inside diameter of the beads with your choice of tubing. For the above, a 20mm bead with a 12 mm inside diameter works good. For the smaller tubing, try a 16 mm bead with a 10mm inside diameter.

Make sure you clean any wood splinters from the inside of the beads with a small knive blade or file, or they will nick the rubber tubing.

Lastly, a good shave (around the base of the cock and scrotum) is really needed.

I use the method around both the cock and scrotum. It can be worn much longer than around just the cock.

To adjust, put it on loose, then stretch out the tubing while pulling up the bead(s) (more than one bead can be used as back up). Either way, watch how tight you set it and how long you leave it on. Watch for any discoloration or feeling of numbness or pain. Then of course loosen.

Total cost = about $5 to $6 for enough to make 2 or 3. And they are far superior to any commercial ones I've tried.

I really should patent this.